The hardware setup shown below includes the Arduino Uno R4, a DHT11 sensor, and the built-in Wi-Fi for email alerts. The DHT11 is connected with VCC to 5V, GND to ground, and the data pin to Digital ...

D0WD, a low-cost alternative to LilyGo T-Display, lets you mirror your desktop monitor over Wi-Fi with an ESP32 ...

Refer to the circuit diagram below for the complete wiring layout. The Raspberry Pi Pico WhatsApp messaging system reads the ...

Let’s start with the simple case: performing an action only when the switch goes active. We’ll assume the switch starts in ...

Soldered Electronics has made ESP32-based e-paper displays for years, starting with the launch of the Inkplate 6 in 2019. The ...

Orange High School senior Aanya Chepyala was recently named the Kiwanis Club of Lander Circle Senior of the Month for ...

Although generally iPads tend to keep their resale value, there are a few exceptions, such as when you find yourself burdened ...

We’ve always been interested in fluidic logic and, based on [soiboi’s] videos, he is too. His latest shows how to use silicone and a vacuum to build a multiplexed dot matrix display.

Hook up the Adafruit BME280 to your Arduino Giga R1. You can use a prototyping shield to simplify connections. Connect the antenna to the Arduino Giga R1 WiFi if you haven't already Connect the ...

Thanks to jaromir-sukuba, and racerxdl for working on firmware to implement C2 protocol via arduino GPIO. This work largely pulls from them, as well as connorpp. C2 is a 2-pin protocol. Any arduino ...

Arduino test code is run to see if the sensors are working properly, with built-in LED flashing when the sensor is triggered, and turning off when the sensor is released. The testing of the keys ...

You don't happen to have a microscopic phone camera yet, do you?